Skip to the end of navigation

Welcome to the Community!

Television - Picture & Sound

Showing results for 
Search instead for 
Do you mean 
Posts: 1
Registered: ‎02-22-2013
Message 1 of 3 (2,610 Views)
Accepted Solution

KDF-50E2000 Rear Projection lamp

Projection lamp went..ordered a new 1..misplaced the door lamp so the tv wld turn on nd turn rite back off then blink red 3 times..ordered a new door..still doing the same thing..what cld the problem be..please help!!
Posts: 96
Registered: ‎01-14-2013
Message 2 of 3 (2,582 Views)

Re: KDF-50E2000 Rear Projection lamp

[ Edited ]

Hello Kearsten,


If the STAND BY indicator on the front of the TV flashes three times, then the lamp cover is not securely mounted. To resolve this issue, ensure the lamp cover is mounted securely.


Try power resetting the TV and check if it resolves the issue.

  • To power reset, turn OFF the TV and unplug the TV power cord from the electrical outlet.
  • Let it remain without power for 60 seconds. After 60 seconds, plug the power cord back into the electrical outlet.
  • If the TV is plugged into a power strip/surge protector, remove it from the power strip/surge protector and plug it directly into the wall outlet and turn it ON.

If the issue is still unresolved, service may be required. Use the following link to setup a repair for your TV.


If my post answers your question, please mark it as an "Accepted Solution."


Posts: 948
Registered: ‎12-13-2012
Message 3 of 3 (2,572 Views)

Re: KDF-50E2000 Rear Projection lamp

There is a microswitch the door has to depress.. Try make sure it is seated properlly and that you got the correct door.
Posted from Facebook

Get Social

Share your ideas Watch YouTube Support Videos follow us on Twitter Visit us on Facebook